![]() ![]() (1) Dip breeching space reamer 7319906 in lard oil and place in chamber through top opening of receiver (Fig. By drilling a 3/16-inch hole through the rear end of the receiver into the operating slide spring hole, good circulation of phosphating solutions and preservative compounds can be obtained. During any refinishing of the barrel and receiver, the gas cylinder, muzzle, and breech end of the barrel must be plugged with corks to prevent solution from entering the bore or the cylinder portion of the gas cylinder. When original finish is reasonably satisfactory, the removal of front and rear sights and the front band to permit sand blasting, in order to obtain the highest quality protective finish, is not required. If practicable, the front sight should be kept mated with the barrel and receiver assembly from which it is removed. When necessary to sand or grit blast to remove rust, or otherwise prepare the barrel and receiver for re-finishing, remove the rear sight and front band. Relocated serial number on cal.30 carbines.Īnd small patch. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |